Zebra T5206R Manuale Utente Scaricare il pdf (Pagina 341)

Fault Messages

341

Ribbon Low Yes 1. The supply spool is

getting low.

2. If there is a large

amount of ribbon

still on the supply

spool, then the

Ribbon Low

message is being

displayed falsely.

1. Replace ribbon.

2. Disable Ribbon Low in the

MEDIA CONTROL menu.

RIBBON OUT

Load Ribbon

Yes 1. The ribbon supply

spool is empty.

2. The ribbon has

broken.

1. Replace ribbon.

2. Reinstall ribbon.

SECURITY CODE

VIOLATION

Yes The software being

used is not correct for

the printer.

1. Load the correct software.

2. Power off the printer for 15

seconds, then power back

on again. If the problem

persists, contact your

authorized customer

service representative.

SECURITY

VIOLATION

Yes The security key is

missing.

Install the security key.

SOFTWARE

ERROR*

Recycle Power

Yes/No 1. Application

software tried to

perform an illegal

printer function.

2. There are

damaged logic

circuits on the

controller PCBA.

1. Recycle the printer power.

If possible, print a job that

has previously worked.

2. If the problem persists,

contact your authorized

service representative.

Speed Exceeds

Validator Limit

Yes The Print Speed or

Slew Speed value is

above 6 IPS as the

power-up default with

the validator option

installed, or the user

attempted to increase

Print Speed or Slew

Speed above 6 IPS.

Change the Print Speed or

Slew Speed value in the

MEDIA CONTROL menu to 6

IPS or less when using the

validator option, and save the

new value as the power-up

default.

Table 17. LCD Message Troubleshooting (continued)

Displayed Message

Can User

Correct?

Explanation Solution

1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 393 394

Commenti su questo manuale

Nessun commento