Zebra LI 72 Guida Utente Scaricare il pdf (Pagina 31)

QL Plus Series User Guide

If you have a printer equipped with the Kickstand option,

you must ﬁrst remove the belt clip retainer as shown in Figure

15, retaining the two screws holding the retainer to the lower

cover. Arrange the communications cable in a broad loop as

detailed above, and capture it in the strain relief feature on the

bottom of the belt clip retainer. Then re-secure the belt clip

retainer to the bottom cover of the printer.

 RefertotheUsingtheAccessoriessectionformoreinformationonthe

useofthekickstandoption

Figure 15: Communications Strain Relief with Kickstand option

1. Remove Belt Clip Retainer,

along with Belt Clip and

Kickstand.

2. Press communications

cable into strain relief feature

on bottom of Belt Clip

3. Reassemble Belt Clip to

bottom cover.

 Thekickstandisnotshowninthisviewforclarity

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 85 86

Nessun commento

Zebra LI 72 Guida Utente Pagina 31