Zebra II Specifiche Scaricare il pdf (Pagina 183)

c = application mode start signal print

Accepted Values:

p = pulse mode – Start Print signal must be de-asserted before it

can be asserted for the next label.

l = level mode – Start Print signal does not need to be de-asserted

to print the next label. As long as the Start Print signal is low

and a label is formatted, the printer will print a label.

Default Value: 0

d = application label error mode

Accepted Values:

e = error mode – the printer will assert the “Service Required”

signal (svce_req - pin 10) on the application port, enter into

pause mode, and display an error message on the LCD

display.

f = feed mode – the printer will print a blank label when the web is

not found where expected to synch the printer to the media.

Default Value: f

e = reprint mode

Accepted Values:

e = enabled – printer will ignore the reprint signal.

d = disabled – printer will reprint the last label printed after the

signal is asserted. If a label is canceled, the label to be

reprinted will also be canceled. This mode consumes more

memory because the last printed label is not released until

reprint.

Default Value: d

f = ribbon low mode

Accepted Values:

e = enabled – printer warning issued when ribbon low.

d = disabled – printer warning not issued when ribbon low.

Default Value: e

ZPL II Programming Guide Volume One: Command Reference for X.10

175

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 261 262

Nessun commento

Zebra II Specifiche Pagina 183